Rockwell-automation 1770, D17706.5.16 Ref Mnl DF1 Protocol Command Bedienungsanleitung Seite 74

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 251
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 73
5–2 Data-link Layer Message Frames
Publication
17706.5.16 - October 1996
Half-duplex protocol uses three types of transmissions:
polling frame
master message frame
slave message frame
The master node transmits both polling frames and master message
frames, and slave nodes transmit slave message frames.
The following figure illustrates the formats of these frames.
The slave message frame has the same format as the full-duplex
message frame. The master message frame is the same as the slave
message frame except that it is prefixed with DLE SOH and an
address to specify a slave station address (STN).
Important: Even if you set your module to use CRC, when you
send a polling frame, it uses a single BCC byte.
BCCENQDLE STN
CMD STSSRC TNSDLE DSTSTXDLE SOH STN
DLE ETX
BCC/
CRC
Data
(command
data)
From common application routines
CMD STSSRC TNSDLE DSTSTX
DLE ETX
BCC/
CRC
Data
(command data)
From common application routines
Polling Frame
Master Message Frame
Slave Message Frame
The BCC field contains the 2's complement of the 8bit sum (module256 arithmetic sum) of the slave station address
(STN) and all the data bytes in the frame. For polling frames, the BCC is simply the 2's complement of STN. The BCC
does not include any other message frame symbols or response symbols.
Halfduplex Protocol
Message Frames
Seitenansicht 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 250 251

Kommentare zu diesen Handbüchern

Keine Kommentare