Rockwell-automation Logix5000 Controllers Tasks, Programs, and Routine Bedienungsanleitung PDF herunterladen (Seite 14)

Chapter 1 Manage tasks

Description

Initially, the controller runs the motion planner and the I/O task (if one exists).

After running the continuous task for 4 ms, the controller triggers the system overhead.

The period for periodic task 1 expires (12 ms), so the task interrupts the continuous task.

After running the continuous task again for 4 ms, the controller triggers the system overhead.

The trigger occurs for event task 1.

Event task 1 waits until the motion planner is done.

Lower priority tasks are delayed.

The continuous task automatically restarts.

The Studio 5000 environment includes a task monitor tool on the distribution

CD. You can use this tool to analyze how tasks are running.

Unscheduled communication occurs only when a periodic or event task is not

running. If you use multiple tasks, make sure that the scan times and execution

intervals leave enough time for unscheduled communication. Use the following

methods to plan enough unscheduled communication time.

1. Verify that the execution time of a highest priority task is significantly less

than its specified period.

2. Verify that the total execution time of all your tasks is significantly less than

the period of the lowest priority tasks.

For example, the following is true in this configuration.

Task Priority Execution Time Period Specified

1 Higher 20 ms 80 ms

2 Lower 30 ms 100 ms

Total execution time: 50 ms

• The execution time of the highest priority task (Task 1) is significantly less

than its specified period (20 ms is less than 80 ms).

• The total execution time of all tasks is significantly less than the specified

period of the lowest priority task (50 ms is less than 100 ms).

Leave enough time for

unscheduled

communication

14 Rockwell Automation Publication 1756-PM005-EN-P - October 2014

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 72 73

Keine Kommentare

Rockwell-automation Logix5000 Controllers Tasks, Programs, and Routine Bedienungsanleitung Seite 14