Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Bedienungsanleitung PDF herunterladen (Seite 14)

Publication 1753-PM001A-EN-P - November 2005

1-4 Connect to the GuardPLC Controller

Change the IP address of your programming terminal running RSLogix

Guard PLUS! software so that the GuardPLC controller and

programming terminal can communicate on a local network.

To change the IP address:

1. In Windows 2000, choose Start>Setting >Control Panel>Network

and Dial-up Connections.

2. Open Local Area Connections and click Properties. Select TCPIP

and click Properties.

3. Set the General TCP/IP Properties as shown below.

4. Confirm your settings by clicking OK in both dialog boxes.

TIP

If you suspect the GuardPLC controller has the

factory-set default IP address of 192.168.0.99 and the

default subnet mask of 255.255.252.0, set your

programming terminal’s IP address to 192.168.0.98

with a subnet of 255.255.252.0 to establish

communications.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 121 122

Keine Kommentare

Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Bedienungsanleitung Seite 14