Rockwell-automation 440G-LZ Guard Locking Switch User Manual Bedienungsanleitung PDF herunterladen (Seite 19)

Rockwell Automation Publication 440G-UM001A-EN-P — November 2013 19

Installation and Wiring Chapter 3

Learning Additional “Multi-Time” Actuators

Mount the new actuator on the guard and repeat the above process.,

introducing the actuator to the switch as previously described. During

program finalization, the LED will blink green a number of times

corresponding to the number of remaining learnable actuators.

Note: Once a new actuator is learned by a unique coded switch, any

previous actuator is no longer usable by that switch.

“One-time” Learning Process

Proceed just as in the “multi-time” teaching process described above,

with the following exception: at the programming finalizing (last) stage,

withdraw the actuator from the switch, until the LED turns solid red, then

immediately reposition the actuator near the switch. This process must

be executed within 15 seconds.

The LED blinks, then turns solid to indicate that the learning process is

complete.

Note: For power-to-release switches, you will need to execute a manual

release in order to withdraw the actuator away from the switch as

described above.

Learning Sequence as Indicated by the Status/Diagnostic LEDs

Actuator present Blinking green, 1 Hz rate

Verifying actuator Blinking green/red, 1 Hz rate (15 sec)

Programming switch (15 sec) Blinking green/red, 4 Hz rate (15 sec)

Program finalization Blinking green (remaining number of times

a new actuator may be acquired, 15 sec)

Ready state (learning process is complete) Solid green (Power-to-release)

Solid red (Power-to-lock)

Power-to-release Solid green

Power-to-lock Solid red

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Keine Kommentare

Rockwell-automation 440G-LZ Guard Locking Switch User Manual Bedienungsanleitung Seite 19