Rockwell-automation 2707-NP DTAM Programming Software Bedienungsanleitung PDF herunterladen (Seite 149)

A–B

Chapter

19–1

Transferring / Printing Application Files

This chapter describes how to transfer application files between a DTAM and

a personal computer. Also provided is a description of how to print out an

application file.

Section Page

Upload / Download DIP Switch Settings 19–1

Communication Cables 19–1

Computer Setup 19–1

Printer Setup 19–1

Downloading an Application 19–2

Uploading an Application 19–6

Printing Application Files 19–9

Before you can upload or download an application, you must verify that the

DIP switches are set properly. Refer to the DTAM Plus or DTAM Micro

user manuals for the upload/download switch settings.

Refer to the accessories list in DTAM Plus or DTAM Micro user manuals for

the proper communication cable. Cable diagrams are provided in these

manuals if you need to construct your own cable.

Upload and download functions are initiated from a personal computer

running the programming software DPS. Transfer functions occur at 9600

baud. Make sure that the computer’s communication port is also set for 9600

baud.

After the transfer is complete, the DTAM Baud rate is set to the parameters

defined by the application program residing in the DTAM Micro or DTAM

Plus.

Make sure that the printer communications port and the DTAM Plus printer

port have matching baud rates, parity and data lengths. Refer to Chapter 14

for a description of the printer port configuration screen.

Chapter Objectives

Upload / Download

DIP Switch Settings

Communication Cables

Computer Setup

Printer Setup

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 183 184

Keine Kommentare

Rockwell-automation 2707-NP DTAM Programming Software Bedienungsanleitung Seite 149