Rockwell-automation 160 RSI SERIAL COMM MODULE Bedienungsanleitung PDF herunterladen (Seite 15)

Installation and Wiring 3–5

Figure 3.3

Communication Module Installation

Removing the RS1 Module

If you need to reconﬁgure the RS1 Module DIP switches, you must

remove the module from the drive.

1. Verify that all power to the drive is removed. Review Attention

statement on page 3–4.

2. Disconnect the cable/connector from the module (if present).

3. Press in on the module’s latch and then push away and up.

4. Grasp the module and pull straight up. Avoid bending or twisting

the contact pins located underneath the center portion of the

module.

Figure 3.4

Removing the Communication Module

1 2 3 4 5 6 7 8 9 10 11

T1

U

T3

W

–

DC

+

DC

T2

V

FAULT

READY

RS232

Serial Comm

COMM

Latch must be in this position

before installation. Once installed,

push the latch down until it locks

into place.

Module should be ﬂush

with top surface of drive

1 2 3 4 5 6 7 8 9 10 11

T1

U

T3

W

–

DC

+

DC

T2

V

FAULT

READY

RS232

Serial Comm

COMM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare