Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Bedienungsanleitung PDF herunterladen (Seite 66)

Troubleshooting the Drive Using the OIM

7-7

Step 2. If the DRIVE READY indicator is off, the drive is not ready to start. If this is

the case, move the cursor to “Why is the drive not ready?” and press .

The screen shows possible explanations of why the drive is not ready. If the

▼ symbol is displayed, more information is available. Press to read the

rest of the screen. Table 7.1 lists all possible responses.

Step 3. Press to exit the screen.

Step 4. Press again at the Diagnostics Menu to return to program or monitor

mode.

7.5 Clearing a Programming Error Screen

Programming errors occur if you select an option that is not valid, such as attempting

to set a read-only parameter. These errors do not affect drive operation and are not

logged. To remove the programming error message, press .

Table 7.1 – Possible OIM Responses to “Why is the Drive Not Ready?”

Display Description

PRE-CHARGE IS NOT READY The DC bus is not within required tolerance.

FP STOP ACTIVE The front-panel STOP key is asserted.

SERIAL STOP ACTIVE The serial port (CS3000) stop input is

asserted.

ACTIVE CS STOP ACTIVE The active control source stop input is

asserted.

DRIVE NOT IDENTIFIED The Power Module has not been identified to

the regulator.

DOWNLOAD IN PROGRESS The CS3000 configuration download

procedure is in progress.

COAST/DB STOP OPEN The coast/DB stop input (TS 23) is open.

CUSTOMER INTERLOCK OPEN The function loss input (TS 20) is open.

MEMORY OPERATION IN

PROGRESS

Non-volatile memory is being restored.

DRIVE IS IN PROCESS OF

STOPPING

The drive is in the process of stopping.

THERE IS A DRIVE FAULT(S) The drive is faulted.

THE DRIVE IS READY. The drive is ready to run.

A STOP INPUT IS ACTIVE A keypad stop key or the selected control

source stop input is asserted.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 111 112

Keine Kommentare

Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Bedienungsanleitung Seite 66