Rockwell-automation 802T Plug-In Limit Switch with Indicating Light Bedienungsanleitung Seite 2

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 1
LEVER POSITIONING
The lever on rotary actuated devices is adjustable to any position
through 360° around the shaft. Loosen the nut, move lever to de-
sired position and securely retighten the nut. (See Figure 3 be-
low).
FIGURE 3
LOCK PIN NUT
CHANGING DIRECTION OF ACTUATION
The switch action of most lever operated limit switches may be
adjusted to operate with either a clockwise, a counterclockwise,
or both direction movement of the shaft. The maintained and
neutral position style of devices operate in both directions and
cannot be changed.
To change actuation direction, follow the steps below:
Important: These procedures must be performed in a clean en-
vironment to avoid introduction of dirt into the oper-
ating mechanism.
Step 1. Loosen the four head mounting screws and re-
move the operating head from the switch body.
Step 2. Locate the plunger on the underside of the operat-
ing head.
Step 3. Pull the plunger outward and rotate it in steps of
90° to provide the operating mode desired. The
respective settings are shown in Figure 4.
Step 4. Make sure the plunger is pushed back inward and
the O ring is properly seated before the operat-
ing head is reattached to the switch body.
Step 5. Securely retighten (approx. 1218 in.-lbs.) the op-
erating head mounting screws.
Step 6. Check for desired actuation mode.
FIGURE 4
CCW ONLY CW & CCW CW ONLY
PLUNGER
ACTUATION
SETTING
REQUIRED
RENEWAL PARTS
If renewal parts or additional lubricant is required, give the bulle-
tin number, catalog number, and series letter found on the name-
plate.
Publication 40146–792–02(A)
July 1993
Printed in USA
Seitenansicht 1
1 2 3 4

Kommentare zu diesen Handbüchern

Keine Kommentare