Rockwell-automation 45MLA Controller Installation Instructions Bedienungsanleitung PDF herunterladen (Seite 14)

Table 26: DIP Switch Array S2 Settings (extension PCB)

(0: OFF, 1: ON, X: not relevant), DIP 2-4 not used

Default Parameters

The termination resistor must be set according to the CAN

architecture in each application and can be switched on through

use of switch 1 on DIP switch array S2. The baud rate and address

offset can be set with DIP switch array S1 (on the main PCB).

Table 20 lists the default values for additional parameters

discussed above (for both RJ485 and CAN models), that can be

reset by use of switch 8 on DIP switch array S1, followed by a

power cycle.

Table 27: Default Parameter Settings for CAN model

Function

DIP switch number on array S2

4321

Default 0000

Terminating resistor (135 ) OFF XXX0

Terminating resistor (135 ) ON XXX1

Parameter Setting Default

Beam counting mode

Command 1C (Hex),

Par 46

0 = First beam cable side

Pitch factor

Command 1C (Hex),

Par 45

Blanked Beams

Command 1C (Hex),

Par 43 and 44

Output logic overhang

Command 1C (Hex),

Par 24

0 = Active "Low"

Over-height

Command 1C (Hex),

Par 25

Output logic over-height

Command 1C (Hex),

Par 26

0 = Active "Low"

Overhang carrier zone

Command 1C (Hex),

Par 23

Overhang trigger mode

Command 1C (Hex),

Par 49

0 = time delay mode

Delay times

Command 1C (Hex),

Par 63, 64 and 65

Dimensions [mm (in.)]

Accessories

Light arrays from the 45MLA family (Cat. No. 45MLA-xxx00Pxx) are

sold as transmitted beam pairs.

200 (7.9)

188 (7.4)

176 (6.9)

128

(5.0)

120

(4.7)

(3.1)

4.5

(0.18)4x

(1.2) 2x

5.0

(0.2) 4x

(1.8)

160 (6.3)

130 (5.1)

Receiver Array

Emitter Array

45MLA Controller

1 2 ... 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Rockwell-automation 45MLA Controller Installation Instructions Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Rockwell-automation 45MLA Controller Installation Instructions