Rockwell-automation 2711E-NK5 Replacing the PanelView 1400E Keypad Fac Bedienungsanleitung Seite 1

Replacing the PanelView1400e Keypad Faceplate(Catalog Number 2711E-NK5)(For PanelView Terminals 2711E-K14C6,2711E-K14C7, 2711E-K14C15)This document pr

Replacing the PanelView 1400e Keypad Faceplate10Test each key by pressing it. If the key is working, thecorresponding key will appear to be pressed o

May 1998PanelView is a trademark of Allen Bradley, Inc.All other brand and product names are trademarks or registered trademarks of their respective c

Replacing the PanelView 1400e Keypad Faceplate2!ATTENTION: To replace the keypad faceplate, youwill need to put the unit face down gently onto a clea

Replacing the PanelView 1400e Keypad Faceplate 3To remove the keypad faceplate:1. Place the terminal face down on a protective surface.2. Use a Torx

Replacing the PanelView 1400e Keypad Faceplate44. Disconnect the cable from the controller board on the keypadfaceplate. Note the position and orient

Replacing the PanelView 1400e Keypad Faceplate 57. Gently pull the keypad faceplate away from the unit at the top.To prepare the new keypad faceplate

Replacing the PanelView 1400e Keypad Faceplate6Pull gently on the blue tabs to remove the legend key inserts fromthe old keypad faceplate and the new

Replacing the PanelView 1400e Keypad Faceplate 7 4. Holding the faceplate in position with one hand, start the middlescrew on one side of the facepla

Replacing the PanelView 1400e Keypad Faceplate87. Start the remaining screws around the outside of the terminal.8. Use the torque wrench to tighten t

Replacing the PanelView 1400e Keypad Faceplate 9To remount and reconnect the terminal:1. Remount the terminal in its rack or panel. Secure the 18 nut