Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Bedienungsanleitung PDF herunterladen (Seite 36)

Chapter 3

Installing the Software

3–10

Modify CONFIG.SYS & AUTOEXEC.BAT Files

The following steps show a sample network setup. Consult with your

network administrator to determine if this setup applies in your environment.

1 Change to the directory containing the PC/TCP drivers. Type:

CD \PCTCP↵

2 At the C:\PCTCP> prompt, type:

RENAME FTP22DOS.INI PROTOCOL.INI

3 Open the CONFIG.SYS file with any ASCII text editor. If you use the

DOS text editor, type:

EDIT C:\CONFIG.SYS↵

Your CONFIG.SYS file contents will appear in the editing window.

4 Move the cursor to the end of the file.

5 Assuming you have installed the Ethernet Board drivers in the directory

C:\PCTCP (the default), be sure the following lines appear in your

CONFIG.SYS file.

DEVICE=C:\PCTCP\PROTMAN.DOS /I:C:\PCTCP

DEVICE=C:\PCTCP\SMC8000.DOS

DEVICE=C:\PCTCP\DIS_PKT.GUP

6 Save the file. If you are using the DOS text editor, type:

[ALT]FXY

7 Open the AUTOEXEC.BAT file with any ASCII text editor. If you use

the DOS text editor, type:

EDIT C:\AUTOEXEC.BAT↵

Your AUTOEXEC.BAT file contents will appear in the editing window.

8 Move the cursor to the end of the file.

9 The following lines should appear in the AUTOEXEC.BAT file. If they

are not there, add them now.

SET PCTCP=C:\PCTCP\PCTCP.INI

C:\PCTCP\NETBIND.COM

C:\PCTCP\ETHDRV.EXE

For additional information regarding installation of your PC/TCP software,

refer to the section on installing an NDIS driver in the PC/TCP Software

Installation Guide.

Restart Your PC

When installation is complete, remove the installation diskette from the 3

inch micro drive and store all installation software in a safe place. Finally,

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 138 139

Keine Kommentare

Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Bedienungsanleitung Seite 36