Rockwell-automation 1798-DFTP2 FlexArmor DeviceNet Field Termination P Bedienungsanleitung PDF herunterladen (Seite 3)

FlexArmor DeviceNet Field Termination Plug 3

Publication 1798-IN004A-EN-P - January 2001

Install Your DeviceNet Field Termination Plug

To install the module:

• Mount the DFTP

• Connect external wiring

These steps are explained in more detail in the following

procedures.

For instructions on how to mount the FlexArmor Baseplate,

refer to publication no. 1798-IN003A-EN-P.

Mount the Field Termination Plug

To mount the Field Termination Plug:

1. Place the DFTP on the left-most slot of the Baseplate.

2. Tighten the 4 screws on the DFTP.

Connect External Wiring

Connect external wiring to the DFTP as shown below.

1. Connect the DeviceNet cable to the DFTP as shown.

IMPORTANT

Torque the screws to 0.5-0.7 Nm. (4.43 - 6.2 inch

pounds).

Connect Connector Pin To

BLK Wire 3 -V

BLU Wire 5 CAN* Low

Bare Wire 1 Drain

1 2 3 4 5 6 7 8

Keine Kommentare

Rockwell-automation 1798-DFTP2 FlexArmor DeviceNet Field Termination P Bedienungsanleitung Seite 3