Rockwell-automation 1794-IP4 Series B FLEX I/O PULSE COUNTER User Manu Bedienungsanleitung PDF herunterladen (Seite 22)

2–6 How to Install Your Pulse Counter Module

-%$,$(' /  -"-+, 

5. Repeat the above steps to install the next terminal base.

Panel/Wall Mounting

Installation on a wall or panel consists of:

• laying out the drilling points on the wall or panel

• drilling the pilot holes for the mounting screws

• mounting the adapter mounting plate

• installing the terminal base units and securing them to the wall or

panel

If you are installing your module into a terminal base unit that is

already installed, proceed to “Mounting the Pulse Counter Module

on the Terminal Base” on page2–7.

Use the mounting kit Cat. No. 1794-NM1 for panel/wall mounting.







1794ĆNM1 Mounting Kit

(', ',+

  (-',$'" %, !(* ), *

    + %!/,))$'" +* .+

 !(* ,# ), * ' 

# !(* -) ,(  &(-% +



), * (-%

'(, $'%- 

 *&$'% + '$,

'(, $'%- 

To install the mounting plate on a wall or panel:

1. Lay out the required points on the wall/panel as shown in the

drilling dimension drawing.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 70 71

Keine Kommentare

Rockwell-automation 1794-IP4 Series B FLEX I/O PULSE COUNTER User Manu Bedienungsanleitung Seite 22