Rockwell-automation 1785 User Mnl. PLC-5 Prog.Control Flash Bedienungsanleitung PDF herunterladen (Seite 2)

Publication 1785-6.2 March 1998 For A-B Internal Use Only

Before You Begin... Gathering What You Need

Gather the following items before you begin using the flash upgrade.

(Items marked with an asterisk (*) are included in the flash tool

package you ordered.)

• flash firmware upgrade tool disk*

• PLC-5 processor whose firmware you want to update

(with chassis and power supply)

• personal computer with PLC-5 programming software installed

• shielded serial cable (1784-CP10 or 1784-CP11)

• this manual*

• firmware revision label*

• plug PROM(s) (if you require a plug PROM firmware update)*

Running the Software

You will copy the flash files to your hard drive.

Using the Flash Tool To successfully use the flash tool, you need to complete seven steps:

1. Prepare the PLC-5 processor.

2. Install the flash tool.

3. Perform the firmware upgrade.

4. Apply the firmware revision label.

5. Update the communication plug firmware, if necessary.

6. Reconnect the PLC-5 processor.

7. Uninstall the flash tool.

ATTENTION: You must install and run the PLC-5

flash tool on a computer booted up in DOS 6.22 or later.

Do not use a DOS window running under Windows

95 or Windows NT.

ATTENTION: Pay strict attention to the flash tool

procedure. Failure to follow this procedure exactly may

result in an inoperable processor.

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Rockwell-automation 1785 User Mnl. PLC-5 Prog.Control Flash Bedienungsanleitung Seite 2