Rockwell Automation 1203-SSS Bedienungsanleitung PDF herunterladen (Seite 95)

Use with HyperTerminal Software E-5

PowerFlex 1203-USB Converter User Manual

Publication DRIVES-UM001D-EN-P

Preparing for a Firmware

Update

Please take the following precautions to ensure a successful firmware

update:

• Obtain the new firmware version from Rockwell Automation. Save it to

the hard drive of the computer. Do not attempt to perform an update from

a removable storage device or a network.

• Read all instructions supplied with the new firmware file.

• Use a computer running terminal emulation software that supports

Xmodem transfers. For example, in this appendix we show how to use

HyperTerminal software.

• Record parameter values in the device that will be updated. Updates may

cause parameters to revert to their default settings.

• Verify that the host drive (for example, a PowerFlex 70 EC drive) is

stopped.

• Close all programs except the terminal emulation program being used to

update the device.

• Disable the screen saver and anti-virus programs so that they do not start

during the update.

• Depending on the type of drive, verify the applicable converter

parameter setting shown below.

Updating Firmware

HyperTerminal software can be used to perform firmware updates on the

1203-USB converter and products that implement DPI or DSI, such as

PowerFlex 7-Class drives and peripherals, or PowerFlex 4-Class

peripherals—but not PowerFlex 4-Class drives.

Important:PowerFlex 400 drives can only be updated using a

AK-U9-FLSH1 flash kit. PowerFlex 4, 40, and 40P drives

cannot be updated. Only PowerFlex 4M drives can be updated

using the 1203-USB converter.

For information to update firmware, see the respective Release Note for the

firmware revision you are updating to on the Allen-Bradley website at

http://www.ab.com/support/abdrives/webupdate

Type of Drive Converter Parameter Required Setting

DPI Drives Parameter 06 - [Interface Mode] ‘0’ (Auto)

DSI Drives Parameter 01 - [Adapter Cfg] ‘0’ (Auto)

SCANport Drives Parameter 06 - [Interface Mode] ‘0’ (Auto)

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 111 112

Keine Kommentare

Rockwell Automation 1203-SSS Bedienungsanleitung Seite 95