Rockwell-automation 193-EDN E1Plus Overload Relays - DeviceNet Module Bedienungsanleitung

USER MANUALBULLETIN 193E1 Plus DeviceNet™ ModuleCATALOG NUMBER 193-EDN

Publication 193-UM006A-EN-P – October 20051-6 Installation and WiringDimensionsFigure 1.6 Dimension DiagramAFGBDEKLHCJTable 1.2 Dimension Speci

1 Publication 193-UM006A-EN-P – October 2005Chapter 2Protection FunctionsIntroductionThe purpose of this chapter is to provide detailed information re

Publication 193-UM006A-EN-P – October 20052-2 Protection FunctionsParameter 13, War ning Enable, allows the installer to enable or disable the

Publication 193-UM006A-EN-P – October 2005Protection Functions 2-3Jam ProtectionMotor current greater than the motor's nameplate rating ca

Publication 193-UM006A-EN-P – October 20052-4 Protection Functions• The E1 Plus Overload Relay's trip relay contacts (95 and 96) will open

Publication 193-UM006A-EN-P – October 2005Protection Functions 2-5Underload WarningThe following parameters are available for configuring the D

Publication 193-UM006A-EN-P – October 20052-6 Protection FunctionsWhen the Comm Fault warning conditions are satisfied, the following will occu

1 Publication 193-UM006A-EN-P – October 2005Chapter 3DeviceNet Node CommissioningUsing RSNetWorx for DeviceNetGoing OnlineTo begin the configuration o

Publication 193-UM006A-EN-P – October 20053-2 DeviceNet Node CommissioningFigure 3.1 Network Online Screen6. If RSNetWorx recognizes the device

Publication 193-UM006A-EN-P – October 2005DeviceNet Node Commissioning 3-3Figure 3.2 Figure EDS Wizard Screen6. (Optional) Do the following:• T

Important User InformationSolid state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines

Publication 193-UM006A-EN-P – October 20053-4 DeviceNet Node Commissioning8. Next to the selected Polled check box, do the following:• Type 6 i

Publication 193-UM006A-EN-P – October 2005DeviceNet Node Commissioning 3-53. Select the E1 Plus Overload Relay located at node 63.4. Select OK.

Publication 193-UM006A-EN-P – October 20053-6 DeviceNet Node CommissioningProduced and Consumed Assembly ConfigurationThe Input and Output Asse

Publication 193-UM006A-EN-P – October 2005DeviceNet Node Commissioning 3-7Choosing the size and format of the I/O data that is exchanged by the

Publication 193-UM006A-EN-P – October 20053-8 DeviceNet Node CommissioningFigure 3.7 Editing Device I/O ParametersCommissioning the Protection

1 Publication 193-UM006A-EN-P – October 2005Chapter 4Device ParametersIntroductionThis chapter describes each programmable parameter and its function.

Publication 193-UM006A-EN-P – October 20054-2 Device ParametersParameter Group ListingThe 193-EDN DeviceNet Module contains six parameter group

Publication 193-UM006A-EN-P – October 2005Device Parameters 4-3Trip Status Parameter No. 3This parameter provides trip identification.1 = Trip0

Publication 193-UM006A-EN-P – October 20054-4 Device ParametersDevice Status Parameter No. 10This parameter provides status information related

Publication 193-UM006A-EN-P – October 2005Device Parameters 4-5Advanced Setup GroupBit Function:1514131211109876543210XTripX WarningXOut AXIn 1

iii Publication 193-UM006A-EN-P – October 2005Table of ContentsChapter 1 —Installation and WiringIntroduction . . . . . . . . . . . . . . . . . . . .

Publication 193-UM006A-EN-P – October 20054-6 Device ParametersBit Function:1514131211109876543210X Not UsedX Not UsedX JamXXXXXXXXXXXXX Not Us

Publication 193-UM006A-EN-P – October 2005Device Parameters 4-7OL Reset Mode Parameter No. 16This parameter defines whether a trip can be autom

Publication 193-UM006A-EN-P – October 20054-8 Device ParametersJam Trip Level Parameter No. 20This parameter sets the jam trip level. Access R

Publication 193-UM006A-EN-P – October 2005Device Parameters 4-9Reset/Lock GroupTrip Reset Parameter No. 14This parameter provides the user with

Publication 193-UM006A-EN-P – October 20054-10 Device ParametersDeviceNet Setup GroupAutoBaudEnable Parameter No. 26When this parameter is enab

Publication 193-UM006A-EN-P – October 2005Device Parameters 4-11Assy Word 0 Param Parameter No. 30This parameter assigns the parameter value to

Publication 193-UM006A-EN-P – October 20054-12 Device ParametersI/O Setup GroupOutA Pr FltState Parameter No. 34This parameter, in conjunction

Publication 193-UM006A-EN-P – October 2005Device Parameters 4-13OutA DN IdlState Parameter No. 38This parameter, in conjunction with parameter

Publication 193-UM006A-EN-P – October 20054-14 Device ParametersTrip History GroupTrip Log 0 Parameter No. 5This parameter records the latest t

Publication 193-UM006A-EN-P – October 2005Device Parameters 4-15Trip Log 4 Parameter No. 9This parameter records the trip previous to Trip Log

Publication 193-UM006A-EN-P – October 2005 iv Appendix A — Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Publication 193-UM006A-EN-P – October 20054-16 Device Parameters

1 Publication 193-UM006A-EN-P – October 2005Chapter 5TroubleshootingIntroductionThe purpose of this chapter is to assist in troubleshooting the E1 Plu

Publication 193-UM006A-EN-P – October 20055-2 TroubleshootingDeviceNet Modes of OperationThe E1 Plus DeviceNet Module has four DeviceNet modes

Publication 193-UM006A-EN-P – October 2005Troubleshooting 5-3Recoverable Error ModeIn Recoverable Error Mode, the E1 Plus DeviceNet Module’s NE

Publication 193-UM006A-EN-P – October 20055-4 TroubleshootingDeviceNet Troubleshooting ProceduresThe following table identifies possible causes

Publication 193-UM006A-EN-P – October 2005Troubleshooting 5-5Input and Output Troubleshooting ProceduresATTENTIONIf the outputs are to be comma

Publication 193-UM006A-EN-P – October 20055-6 TroubleshootingOUT A Output A does not appear to turn on (close) when commanded to do so.1. Chec

Publication 193-UM006A-EN-P – October 2005Troubleshooting 5-7Trip and Warning Troubleshooting ProceduresThe following table lists the possible

Publication 193-UM006A-EN-P – October 20055-8 Troubleshooting

1 Publication 193-UM006A-EN-P – October 2005Appendix ASpecificationsTerminal Ratings:Terminal Screw M3Wire Cross Section See wiring diagram sectionTor

1 Publication 193-UM006A-EN-P – October 2005Chapter 1Installation and WiringIntroductionThe purpose of this chapter is to provide the necessary instru

Publication 193-UM006A-EN-P – October 2005A-2 SpecificationsRecommended Control Circuit Fuse KTK-R-6(6 A, 600V)Rated Number of Operations

Publication 193-UM006A-EN-P – October 2005Specifications A-3RF Immunity Test Level

Publication 193-UM006A-EN-P – October 2005A-4 Specifications

1 Publication 193-UM006A-EN-P – October 2005Appendix BDeviceNet InformationElectronic Data SheetsElectronic Data Sheet (EDS) files are specially forma

Publication 193-UM006A-EN-P – October 2005B-2 DeviceNet InformationIdentity Object — CLASS CODE 0x0001The following class attributes are suppor

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-3The following common services are implemented for the Identity Object:Messag

Publication 193-UM006A-EN-P – October 2005B-4 DeviceNet InformationThe following services are implemented for the DeviceNet Object:Assembly Obj

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-5Input AssembliesTable B.13 Instance 50 — Basic Overload Input Assembly from

Publication 193-UM006A-EN-P – October 2005B-6 DeviceNet InformationThe following services are implemented for the Assembly Object:Table B.18 De

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-7Connection Object — CLASS CODE 0x0005No class attributes are supported for t

Publication 193-UM006A-EN-P – October 20051-2 Installation and WiringATTENTIONOnly personnel familiar with the side mount module and associated

Publication 193-UM006A-EN-P – October 2005B-8 DeviceNet InformationInstance 4 is the Predefined Group 2 Connection Set Change of State/Cyclic I

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-9Instances 5…7 are available group 3 Explicit Message Connections that are al

Publication 193-UM006A-EN-P – October 2005B-10 DeviceNet InformationDiscrete Input Point Object — CLASS CODE 0x0008The following class attribut

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-11A single instance is implemented and contains the following attributes:The

Publication 193-UM006A-EN-P – October 2005B-12 DeviceNet InformationParameter Object —CLASS CODE 0x000FThe following class attributes are suppo

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-13The following commons services are implemented for the Parameter Object:Par

Publication 193-UM006A-EN-P – October 2005B-14 DeviceNet InformationThe following common services are implemented for the Parameter Group Objec

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-15The following common services are implemented for the Control Supervisor Ob

Publication 193-UM006A-EN-P – October 2005B-16 DeviceNet InformationAcknowledge Handler Object — CLASS CODE 0x002BNo class attributes are suppo

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-176.12. Overload Object —CLASS CODE 0x002CNo class attributes are supported f

Publication 193-UM006A-EN-P – October 2005Installation and Wiring 1-3FeaturesFigure 1.1 FeaturesNetwork Status LEDOutput Status LEDInput Status

Publication 193-UM006A-EN-P – October 2005B-18 DeviceNet InformationA single instance (instance 1) of the DeviceNet Interface Object is support

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-19ODVA Fault CodesThe following ODVA fault codes are returned by the Control

Publication 193-UM006A-EN-P – October 2005B-20 DeviceNet Information

Publication 193-UM006A-EN-P – October 2005DeviceNet Information B-21

Publication 193-UM006A-EN-P – October 2005B-22 DeviceNet Information

Publication 193-UM006A-EN-P — October, 2005Copyright ©2005 Rockwell Automation, Inc. All Rights Reserved. Printed in USA.Rockwell Automation SupportRo

Publication 193-UM006A-EN-P – October 20051-4 Installation and WiringInstallationFigure 1.2 Installation [1]Figure 1.3 Installation [2]Figure 1

Publication 193-UM006A-EN-P – October 2005Installation and Wiring 1-5Wiring Figure 1.5 Wiring DiagramATTENTIONWhen using 4-conductor DeviceNet